Mesh generation
Beware of CFL number
You may be familiar with the CFL restriction associated with explicit (mode-splitting) modele; the CFL number, defined as
CFL=(|u|+sqrt(g*h))*dt/dx
must be <1 for given dx,dt. Here h is the local water depth, and u is the flow velocity.
Being an implicit model using Eulerian-Lagrangian method (ELM), SELFE has a somewhat opposite requirement: CFL>0.4. Therefore care must be taken in the grid generation process; otherwise numerical diffusion in ELM would ruin your results, which may manifest itself in the form of either noise or dissipation.
With xmgredit5, you can very easily visualize CFL for the entire grid. Note, however, that CFL number is undefined when h<0. In these shallow regions, we should use |u| alone and neglect the wave celerity term (sqrt(g*h)). E.g., if we estimate |u| ~ 1m/s, with a time step of 100s, the max. dx should be 250m; with dt=50s, dx_max=125m.
- xmgredit5 -belel -1.e-10 hgrid.gr3 (note: '-belel -1.e-10' is used mainly to increase precision for lat/lon grid)
- [[since the CFL inside ACE is calculated without u, we should impose a min depth of 0.1 (so that sqrt(g*h)>=1m/s); you can do this by: Edit]]
Baratropic simulation
Grid quality requirement is relatively lax for barotropic simulations. Besides the CFL above, you mainly need to use appropriate resolution based on physics (e.g., coarser resolution in deeper depths and finer resolution for shallow depths).
Baroclinic simulation
The transport process is influenced by your choice of grid.
